ChurchsetupShow/Hide Chords-Transpose ♯↔♭+Print Form for IC to be completed before the service.Section 1 - MIXING AND AUDIOConfirm Musician *Confirm musician roster and song list.YESNONAConfirm the Musician roster. *( Musician, name, instrument, and/or vocal).YESNONAGet a service order and additional audio. *get a service order and additional needsPlay backing trackAnnouncementsHave checked Audio LevelLogical channel layout ( If Applicable ). *Check if any changes to the mixing console, vocal, drums, etc.YESNONALast week's settings have been saved or cleared. *Mak sure last week's settings have been cleared ( gates, compressors, etc ) - important step when band changes or channels change.SavedClearedDrop DownSelect profile. *BobbyImmanNex-GenOct 1Battery Check. *Perform battery check: rechargeable batteries charged, new batteries in place, old batteries with acceptable life, etc.YESNONACheck instrument microphone. *Check instrument microphone placement ( drums, guitar amp microphone, etc.)YESNONACheck direct box connections. *Check direct box connections: input cable to the input jack, output jack to the output cable.YESNONAPerform safety check. *Perform a safety check on stage; walking paths clear of cables and gear, cables secured to stage if in the path, etc.YESNONAPower up Equipment. *Power up equipment in proper order; power amps on last. Check power lights on equipment to ensure they are on.YESNONAPerform a Line Check. *Perform a line check. Do this before the soundcheck if musicians or another person can help. Otherwise, do it at the start of soundcheck.YESNONACheck with all musicians present. *Check with all musicians present. Confirm every input sends a signal to the console.YESNONASet gain for each channel. *- Set gain for each channel. - Remember the need for a high signal-to-noise ratio, maximum gain before feedback; and leaving headroom to avoid distortion so adjust the gain accordingly. - Must record post service or saved in profile. - Tip: Start with the fader at zero and increase gain to meet . expectations.YESNONARun the Master fader. *Run the master fader a little louder to account for the lack of people in the seats. Or, run it just under unity and boost once the service starts. Either way, people soak up the sound so account for that.FOHMONITORSIEMPerform a rough volume balance. *Perform a rough volume balance so lead vocals are on top and other channels fall in place.YESNONAperform a rough channel EQ. *Perform a rough channel EQ - no more than fifteen seconds spent per channel. Changes to be recorded or saved.YESNONASet monitor mixes. *Set monitor mixes for floor wedges. If using in-ear systems, allow musicians to set monitors.YESNONABlend and contrast channels. *Blend and contrast channels; backing singers blend, lead guitar stands out over rhythm, etc. Add in effects as needed.YESNONANote who leads each song. Note who leads each song - important if the worship team has multiple singers.YESNONANote any instrument solos. *Note any instrument solos for appropriate mixing - important if arrangement differs from the original recording.YESNONAEnsure an even-sounding mix. *Walk the room to ensure an even-sounding mix in the majority of the room. Make mix adjustments if appropriate.YESNONACheck spoken-word microphones. *Check spoken-word microphones such as pulpit microphones, handhelds, and the pastor's microphone.YESNONACheck with the musicians for gear problems. *Check with the musicians for gear problems.YESNONACheck with musicians for monitor levels problem. *Check with musicians for monitor levels problems.YESNONACheck battery levels. *Check battery levels on wireless devices. Lock device settings if possible.YESNONAPrepare for service recording. Prepare for service recording and/or live streaming ( computer recording, CD, etc. )YESNONASection 2 - POWER SETUPMonitor A ( Black extn plug point ). *ONOFFNAMonitor B ( Black extn plug point ). *ONOFFNASwitch On Drums *ONOFFNASwitch On plug point near Keyboard. *ONOFFNACheck Switches behind the Stage. *ONOFFNASwitch On TV. *ONOFFNAMoving Head A ( behind stage ). *ONOFFNAMoving Head B ( behind stage ). *ONOFFNAMoving head ( Martin ) A. *ONOFFNASwitch On the PA system Power Sequencer. *ONOFFNASwitch On Mackie Personal Monitor. *ONOFFNASwitch On all plugs for Wireless devices. *ONOFFNAPlug/Wind the 1/4 jack cables for Guitar. *ONOFFNAHang Guitar cables in Guitar stand. *YESNONASwitch On Aircon on stage. *ONOFFNASwitch On the Mixer. *ONOFFNASwitch in all the plugs for wireless device. *ONOFFNAStage DMX lights ( Switch near the console area ). *ONOFFNAStage Spot lights ( Switch near the console area ). *ONOFFNAEmail Date VerificationPlease enter any two digits *Example: 12This box is for spam protection - <strong>please leave it blank</strong>:
